HONDA 2015 CR-Z - Owner's Manual - Manual (Page 280)

Continued 279
uu If a Tire Goes Flat u Changing a Flat Tire *
Han
d
lin
g the U
n
expected
1. Remove the wheel nuts and flat tire.
2. Wipe the mounting surfaces of the wheel
with a clean cloth.
3. Mount the compact spare tire.
4. Screw the wheel nuts until they touch the
lips around the mounting holes, then stop
rotating.
5. Lower the vehicle and remove the jack.
Tighten the wheel nuts in the order
indicated in the image. Go around,
tightening the nuts, two to three times in
this order.
Wheel nut torque:
80 lbf∙ft (108 N∙m, 11 kgf∙m)
■ Replacing the Flat Tire 1 Replacing the Flat Tire
Do not over tighten the wheel nuts by applying extra
torque using your foot or a pipe.
15 CR-Z-31SZT6400.book 279 ページ ２０１４年８月１日 金曜日 午後１時５９分