HONDA 2010 Accord Crosstour - Owner's Manual - Manual (Page 349)

To change the passenger’s side
bulb, start the engine, turn the
steering wheel all the way to the
left, and turn off the engine. To
change the driver’s side bulb, turn
the steering wheel to the right.
Use a flat-tip screwdriver to
remove the holding clip from the
inner fender, and remove the
screw with a Phillips-head
screwdriver.
Pull the inner fender cover away
from the fender and bumper.
Remove the electrical connector
from the bulb by pushing on the
tab to unlock it, then slide the
connector off the bulb.
Remove the bulb by turning it
approximately one-quarter turn
counterclockwise.
Install the new bulb, and turn it
one-quarter turn clockwise to lock
it in place.
Push the electrical connector onto
the bulb.
Turn on the headlights to test the
new bulb.
Put the inner fender cover in place.
Install the holding clip. Lock it in
place by pushing on the center.
Tighten the screw securely.
3.
4.
5.
1.
2.
6.
7.
8.
9.
Low Beam Headlight
Lights
346
BULB
TAB
SCREW
HOLDING CLIP
ELECTRICAL CONNECTOR
09/09/29 17:51:28 31TP6600_351
2010 Accord Crosstour