HONDA 2007 Accord Hybrid - Owner's Manual - Manual (Page 218)

To change the passenger’s side
bulb, start the engine, turn the
steering wheel all the way to the
left, and turn off the engine. To
change the driver’s side bulb, turn
the steering wheel to the right.
Use a flat-tipped screwdriver to
remove the two holding clips from
the inner fender.
Pull the inner fender cover away
from the fender and bumper.
Remove the electrical connector
from the bulb by squeezing the
connector to unlock the tab, then
slide the connector off the bulb.
Install the new bulb, and turn it
one-quarter turn clockwise to lock
it in place.
Push the electrical connector onto
the bulb.
Turn on the headlights to test the
new bulb.
Put the inner fender cover in place.
Install the two holding clips. Lock
each one in place by pushing on
the center.
Remove the bulb by turning it
about one-quarter turn
counterclockwise.
3.
4.
5.
1.
2.
6.
7.
8.
9.
Low Beam Headlight
Lights
Ma
int
e
na
nce
215
HOLDING CLIPS
BULB
06/08/08 14:51:01 31SDR620_220
Main Menu Table of Contents s t Main Menu ▲ ▼ Main Menu ▲ ▼ Table of Contents