HONDA 2007 Pilot - Owner's Manual - Manual (Page 244)

Install a new oil filter according to
the instructions that come with it.
Let the engine run for several
minutes, then check the drain bolt
and oil filter for leaks.
Refill the engine with the recom-
mended oil.
Engine oil change capacity
(including filter):
Reinstall the engine oil fill cap.
Start the engine. The oil pressure
indicator should go out within 5
seconds. If it does not, turn off the
engine, and check your work.
Turn off the engine and let it sit
for several minutes, then check
the oil level on the dipstick. If
necessary, add more oil.
Remove the oil filter, and let the
remaining oil drain. A special
wrench (available from your
dealer) is required.
Make sure the oil filter gasket is not
stuck to the engine block. If it is,
remove it before installing a new oil
filter.
Put a new washer on the drain bolt,
then reinstall the drain bolt.
Tighten the drain bolt to:
3.
4.
5.
6.
7.
8.
9.
Changing the Oil and Filter
Ma
int
e
na
nce
241
OIL FILTER
29 lbf·ft (39 N·m , 4.0 kgf·m)
4.5 US qt (4.3 )
Improper disposal of engine oil can be
harmf ul to the environment. If you
change your own oil, please dispose of
the used oil properly. Put it in a sealed
container, and take it to a recycling
center. Do not discard it in a trash bin
or dump it on the ground.
Main Menu Table of Contents