Automatic transmission fluid – HONDA 2007 Pilot - Owner's Manual User Manual

Page 247

Advertising
background image

Check the fluid level with the engine
at normal operating temperature.

Remove the dipstick and check
the fluid level. It should be
between the upper and lower
marks.

Insert the dipstick all the way into
the transmission securely as
shown in the illustration.

Remove the dipstick (yellow loop)
from the transmission, and wipe it
with a clean cloth.

Park the vehicle on level ground.
Start the engine let it run until the
radiator fan comes on, then shut
off the engine. For accurate
results, wait about 60 seconds
before going step 2, but don’t wait
longer than 90 seconds.

If the level is below the lower
mark, remove the fill plug, then
add the fluid into the fill hole to
bring it to the level between the
upper and lower marks on the
dipstick.

Pour the fluid slowly and carefully
so you do not spill any. Clean up
any spill immediately; it could
damage components in the engine
compartment.

If you are not sure how to add
fluid or you do not have the proper
equipment to reach the
transmission fluid fill hole, you
should have this maintenance
done by a skilled technician.

1.

2.

3.

4.

5.

Automatic Transmission Fluid

Automatic Transmission

244

DIPSTICK

DIPSTICK

UPPER MARK
LOWER MARK

Main Menu

Table of Contents

Advertising