HONDA 2006 Accord Sedan - Owner's Manual - Manual (Page 133)

The ignition switch must be in
ACCESSORY (I) or ON (II). Make
sure the open side of the tape is
facing right, then insert the tape
most of the way into the slot. The
system will pull the tape in the rest
of the way, and begin to play it.
The tape direction indicator will light
to show you which side of the tape is
playing. The
indicates the side
you inserted upward in now playing.
If you want to play the other side,
press the Preset 3 (PLAY/PROG)
side of the preset bar or press the
AUDIO DISPLAY button and touch
the PROG icon. When the player
reaches the end of the tape, it will
automatically reverse direction and
play the other side.
Dolby noise reduction turns on
when you insert a tape. The
indicator will light in the
display. If the tape was not recorded
in Dolby, turn it off by pressing the
Preset 4 (NR) side of the preset bar
or touching the NR icon. Dolby
remains off until you press the
preset bar or the icon again.
Dolby noise reduction
manufactured under license from
Dolby laboratories licensing
Corporation. ‘‘Dolby’’ and the
double-D symbol are trademarks
of the Dolby Laboratories
Licensing Corporation.
To remove the tape, press the
EJECT button on the cassette player.
If you want to turn the player off,
press the PWR/VOL knob or turn
off the ignition. The tape will remain
in the drive.
When you turn the system back on,
the tape player will be in pause mode.
Press the Preset 3 (PLAY/PROG)
side of the preset bar or touch the
PROG icon on vehicles with
navigation system to resume play.
To switch to the radio or CD player
while a tape is playing, press the
AM/FM, or CD/AUX button or CD/
AUX XM button. To change back to
the tape player, push the CD/AUX
button or CD/AUX XM button.
Optional on all U.S. models
To Play a Tape To Stop Playing a Tape
Playing a Tape (U.S. Vehicles)
132