HONDA 2006 Accord Sedan - Owner's Manual - Manual (Page 159)

4-cylinder models
4-cylinder models
6-cylinder models
6-cylinder models
Pull the support rod out of its clip
and insert the end into the hole on
the front of the hood near the
center.
To Close the Hood:
Lift it up slightly to remove the
support rod from the hole. Put the
support rod back into its holding clip.
Lower the hood to about a foot (30
cm) above the fender, then let it
drop. Make sure it is securely
latched.
Lower it to about a foot (30 cm)
above the fender, then press down
firmly with your hands. Make sure it
is securely latched.
Lift the hood up most of the way.
The hydraulic supports will lift it
up the rest of the way and hold it
up.
3.
Service Station Procedure
158
SUPPORT ROD
6-cylinder models 4-cylinder models