HONDA 2006 Accord Sedan - Owner's Manual - Manual (Page 72)

Push the button between the center
vents to turn on the hazard warning
lights (four-way flashers). This
causes all four outside turn signals
and both turn indicators in the
instrument panel to flash. Use the
hazard warning lights if you need to
park in a dangerous area near heavy
traffic, or if your vehicle is disabled. The Select/Reset knob on the
instrument panel controls the
brightness of the instrument panel
lights. Turn the knob to adjust the
brightness.
The instrument panel will illuminate
with reduced brightness when you
unlock and open the driver’s door.
The brightness will increase slightly
when you insert the key in the
ignition switch, then go to normal
brightness when you turn the
ignition switch to ON (II).
If you do not insert the key in the
ignition switch after opening the
driver’s door, the illumination turns
off about 30 seconds after you close
the door.
If you insert the key but do not turn
the ignition switch to ON (II), the
illumination turns off in about 10
seconds.
To reduce glare at night, the instru-
ment panel illumination dims when
you turn the light switch to
or
. Turning the Select/Reset
knob fully to the right until you hear
a click will cancel the reduced bright-
ness.
Hazard Warning Instrument Panel Brightness
Instrument Panel Brightness, Hazard Warning
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
71
U.S. model shown SELECT/RESET KNOB