HONDA 2001 Accord Sedan - Owner's Manual - Manual (Page 247)

Cooling System
5. When the coolant stops draining,
tighten the drain plug at the
bottom of the radiator.
6. 4-cylinder models
Put a new washer on the drain bolt,
then reinstall the drain bolt in the
engine block. Tighten it securely.
Tightening torque:
61 Ibf.ft (83 N.m , 8.5 kgf.m)
6-cylinder models
Tighten the drain bolt at the rear
of the engine cylinder block
securely.
Tightening torque:
7 Ibf.ft (10 N.m, 1.0 kgf.m)
7. 4-cylinder models
Loosen the bleeder bolt on top of
the engine.
Pour Honda All Season
Antifreeze/Coolant Type 2 into
the radiator. This coolant is a
mixture of 50 percent anti-freeze
and 50 percent water. Pre-mixing
is not required.
Tighten the bleeder bolt when
coolant comes out in a steady
stream with no bubbles.
Maintenance
RESERVE TANK RESERVE TANK CAP
HOLDER 6-cylinder models 4-cylinder models Fill up to here
FILLER NECK FILLER NECK
Fill up to here 6-cylinder models
Main Menu Main Menu Main Menu
Main Menu Table of Contents