HONDA 2000 Civic Sedan - Owner's Manual - Manual (Page 226)

Lights
Replacing Rear Bulbs
(in Fenders)
1. Open the trunk.
Undo the fastener on the side of
the trunk lining by pushing on the
center of the fastener's head until
it pops in. Pull the lining back.
2. Determine which of the two bulbs
is burned out: stop/taillight/side
marker light or turn signal light.
3. Remove the socket by turning it
one-quarter turn counterclockwise.
4. Pull the bulb straight out of its
socket.
Push the new bulb straight into
the socket until it bottoms.
5. Reinstall the socket into the light
assembly by turning it clockwise
until it locks.
6. Test the lights to make sure the
new bulb is working.
7. Reinstall the trunk lining. Make
sure it is installed under the edge
of the trunk seal.
CONTINUED
Maintenance
Main Menu Table of Contents