HONDA 2000 Civic Coupe - Owner's Manual - Manual (Page 99)

Audio System
On DX and HX models in the U.S., and
the DX model in Canada
AM/FM Stereo Audio System
Your Honda's audio system provides
clear reception on both AM and FM
bands, while the preset buttons allow
you to easily select your favorite
stations.
Operating the Radio
The ignition switch must be in
ACCESSORY (I) or ON (ID to
operate the audio system. Turn the
system on by pressing the PWR/
VOL knob or the AM/FM button.
Adjust the volume by turning the
knob.
The band and frequency that the
radio was last tuned to is displayed.
To change bands, press the AM/FM
button. On the FM band, ST will be
displayed if the station is broadcast-
ing in stereo. Stereo reproduction on
AM is not available.
You can use any of three methods to
find radio stations on the selected
band: TUNE, SEEK, or the Preset
buttons.
TUNE — Use the TUNE/SEEK bar
to tune the radio to a desired
frequency. Press the right side ( )
to tune to a higher frequency, or the
left side ( ) to tune to a lower
frequency. The frequency numbers
will start to change rapidly. Release
the bar when the display reaches the
desired frequency. To change the
frequency in small increments, press
and release the TUNE/SEEK bar
quickly.
SEEK — The SEEK function
searches the band for a station with
a strong signal. To activate it, press
the TUNE/SEEK bar until you hear
a beep, then release it. Depending on
which side of the bar you press, the
system scans upward or downward
from the current frequency. It stops
when it finds a station with a strong
signal.
Preset — You can store the
frequencies of your favorite radio
stations in the six preset buttons.
Each button will store one frequency
on the AM band, and two
frequencies on the FM band.
Comfort and Convenience Features
Main Menu Table of Contents