IC Realtime 3Mp Full HD Network PTZ Dome Camera (ICIPP3020HD) - Manual (Page 12)

12
1.2.6 Secure the speed dome to the flange
Please check the rubber airproof ring of the speed dome adjacent to the flange is proper or not.
Use the internal hex screwdriver to fix IR speed dome and the flange to complete the installation.
See Figure 1-5.
Important
Please make sure the airproof ring is firmly secured in the slot. Please make sure you
have secured the inner hex screws firmly. Otherwise, it may result in low waterproof
capability and speed dome malfunction.
Figure 1-5
1.3 Initial Setup
The default setup is:
z Address:
1
z Baud rate: 9600
1.4 Dial Switch Setup
The two dial switches of the speed dome are SW1 and SW2. These are to specify the speed
dome parameter such as protocol, baud rate, address and etc. When the button is ON, it is 1. In
the SW1 and SW2, 1 is the lowest bit and the 8 is the highest bit. See Figure 1-6.
Please note this series speed dome cans automatically recognize the DH-SD, PELCO-D.
PELCO-P. Usually you do not need to set the protocol.