ILY All-in-One Duplicator - Manual (Page 35)

II. Function Introduction
•
Eject Target Only: Only eject target trays with disc inside once the
system is booted up.
•
Eject Source Only: Only eject source disc once the system is
booted up.
•
Eject All Trays: To eject all trays once the system is
booted up.
8-5. Reader Speed
This setting allows you to adjust the reading speed of source drive. The
default setting of reader speed of CD is 40X; DVD is 24X.
8-6. Compare Speed
The reading speed of drive and disc are the reasons that affect the quality of
comparison. This setting allows you to adjust the reading speed of target
drives to match up the reading speed of discs. The default setting of CD’s
compare speed is 40X, DVD is 8X.
8-7. Language
You can set a proper language for interface during operation.
8-8. Clear Setup
This setting will reset all the function back to manufacturer’s default setting.
8-9. Advanced Setup
•
Power On Time: You can set a warm-up time from 5 to 99
seconds for warming up the duplicator when it is turned on. The
default setting is 10 seconds.
•
Start-up Menu: You can select which function you would like to
show up in the beginning.
•
Skip Read Error: You can set this function enable to skip disc
errors in order to avoid bad quality of copy. If you are confident of
your source disc has only a small and insignificant error due to
physical damages and can be overlooked, you can set NO to
disable this function.
35