Interlogix MC352-4P-2S - Manual (Page 20)

- 20 -

Link status auto detect and redundant on Dual ports with same connector type.

Only Primary-Port is active at a time, the Backup-Port is blocked.

When Primary-Port link failure occurs, the traffic swaps to Backup-Port automatically.

Once the Primary-Port status is back to link up, the traffic will swap from Backup-Port to
Primary-Port.
2.2 Mounting Installation
This section describes how to install the Industrial Gigabit PoE+ Switch and make connections to it.
Please read the following topics and perform the procedures in the order being presented.
In the installation steps below, this Manual uses IGS-801 (IFS 8 Port Industrial Gigabit
Switch) as the example. However, the steps for IFS Industrial Gigabit PoE+ Switch are
similar.
2.2.1 DIN-Rail mounting
The DIN-Rail is screwed on the Industrial Gigabit Ethernet Switch when out of factory. When needed to
replace the wall mount application with the DIN-Rail application on Industrial Gigabit Ethernet Switch,
please refer to the following figures to screw the DIN-Rail on the Industrial Gigabit Ethernet Switch. To
hang the Industrial Gigabit Ethernet Switch, follow the steps below:
Step 1: Screw the DIN-Rail on the Industrial Gigabit Ethernet Switch.