Interlogix MCR200-1T-1TW - Manual (Page 16)

IFS MCR200-1T-1TW User Guide 13
Figure 3: MCR200-1T-1TW LAN to LAN connection
Connecting the MCR200-1T-1TW
Connecting Standalone PC
Refer to the following procedures to setup the MCR200-1T-1TW to a
standalone PC.
1. Set the MCR200-1T-1TW to be CO or CPE mode from the DIP switch at
the rear panel.
2. Power on the MCR200-1T-1TW by connecting its power source.
3. Power LED will illuminate.
Connect VDSL line from another VDSL device to VDSL port of
4. The MCR200-1T-1TW.
5. LNK LED will blink to illuminate.
6. Connect telephone to the PHONE port.
7. Connect Ethernet port to PC Network Interface Card (NIC) via regular Cat.
5, 5e or 6 cable.
Figure 3-4: Connecting Standalone PC