Troubleshooting – Interlogix MCR200-1T-1TW User Manual
Page 20
IFS MCR200-1T-1TW User Guide 17
Troubleshooting
SYMPTOM: VDSL LNK LED does not light after wire is connected to the
VDSL port.
CHECKPOINT:
1.
Verify the length of the wire connected between two MCR200-1T-1TW is not
more than 2.0km. Please also try to adjust the DIP switch of MCR200-1T-
1TW to other SNR mode.
2.
Please note you must use one MCR200-1T-1TW with CO mode and the other
MCR200-1T-1TW with CPE mode, connect to each other to make it work.
SYMPTOM: TP LED does not light after cable is connected to the port.
CHECKPOINT:
1.
Verify you are using the Cat.5, 5e or 6 cables with RJ-45 connector to
connect to the port.
2.
If your device (like LAN card) supports to Auto-Negotiation, please try to
modify at a fixed speed of your device by manually.
3.
Check the converter and the connected device’s power are ON or OFF.
4.
Check the port’s cable is firmly seated in its connectors in the switch and in
the associated device.
5.
Check the connecting cable is good.
Check the power adapters are functional, including the connecting device.