Interlogix MCR200-1T-1TW - Manual (Page 5)

2 IFS MCR200-1T-1TW User Guide
Introduction
Checklist
Check the contents of your package for following parts:
Š MCR200-1T-1TW
Š
5V DC/ 2A AC-to-DC Power Adapter x1
Š
RJ-11 Telephone Line x1
Š User’s
Manual x1
If any of these items are missing or damaged, please contact your dealer
immediately, if possible, retain the carton including the original packing
material, and use them against to repack the product in case there is a
need to return it to us for repair.
Ethernet over VDSL2 Bridge Description
UTC's state-of-the-art Ethernet-over-VDSL2 products are based on two
core networking technologies: Ethernet and VDSL2 (Very-high-data-rate
Digital Subscriber Line 2). This technology offers the absolute fastest
possible data transmission speeds over existing copper telephone lines or
coaxial cables without the need for rewiring.
The MCR200-1T-1TW Ethernet Over VDSL2 Converter has a switching
architecture with RJ-45 10/100Mbps Ethernet port and one asymmetric or
symmetric Ethernet over VDSL port (Asymmetric means upstream and
downstream rate are not the same and Symmetric means upstream and
downstream rate are similar) – the VDSL port can be RJ-11 connector
MCR200-1T-1TW. The MCR200-1T-1TW can be set to Central Office (CO)
or Customer Premises Equipment (CPE) mode via a DIP switch. When
MCR200-1T-1TW is connected with other MCR200-1T-1TW devices, the
performance will up to 100/55Mbps for asymmetric data rate within 200m
and up to 25/4Mbps for asymmetric data rate at 1.6km.