Interlogix XL 4 Zone LCD - Manual (Page 12)

Multi-Tenant Security System User Guide
10 MONITOR ISM™/AFx™ Multi-Tenant Security System User Guide 22-9050 v1.3
Keypad Lights continued
Light Display Meanings
• Armed and Trouble
•
Sensor Zone
– combined
– Flashing
– On − Indicates the system had an alarm condition, when the
system is turned off.
−
The sensor zone that had the alarm will indicate by being
on.
− Stops automatically or
press X to stop on 8 Zone Keypad.
press # to stop on 2 Zone Keypad.
• Ready, Armed and
Trouble
• Sensor Zone(s)
– combined
– Flashing
– On − Walk Test in progress. Protection point lights will turn on
as their sensor is tripped and cleared (open, close door) to
indicate their working OK.
Press X to stop test on 8 Zone Keypad.
Press # to stop test on 2 Zone Keypad.
−
Identifying a User’s ID # (8 Zone Keypad only). See
Additional Commands above.
8 Zone Keypad Only
Fire
On
−
A fire-sensing device (smoke sensor) has been
triggered.
−
The sensor zone light the sensor is connected to
may also be on.
−
Enter your PIN at the keypad to stop the keypad
alarm.
−
When the fire condition has been cleared, the
keypad fire lights should reset automatically.
8 and 2 Zone Keypad Tone Descriptions
Tone Type Sound Meanings
Chime Two short beeps − A disarmed entry zone, like the front door, is
being opened and the chime is on to warn
about it.
Alarm/Trouble warning Continuous tone − When ever a warning condition is detected.
− Enter PIN at either keypad to stop.
Fire
8 and 2 Zone Keypads Tone turns on and off − Fire detected.
− NOTE: The 2 Zone keypad does not have an
actual Fire Light but example: its sensor zone
#2 could have a smoke sensor connected to
it. This will cause the 2 Zone to act similarly
to the 8 Zone keypad when a possible fire
condition is sensed.
− Follow instructions for the 8 Zone keypad fire
light above.
Entry/Exit Pulsing tone − When leaving or entering by the front door.
“Entry/Exit delay is ending”
warning Tone pulses rapidly − Last 15 seconds of normal entry or exit.