Philips AJ 3240/00 - Manual (Page 4)

installation Radio/Clock
m
3
<a
E)'
3-
BUTTONS RADIO
0 RADIO switch
- ON - the radio is switched on
- OFF - the radio is switched off
0 ALARM switch 2:
- OFF - alarm off
- RADIO - for waking up by radio
- BUZZER - for waking up by buzzer
0 ALARM switch 1:
- OFF - alarm off
- RADIO - for waking up by radio
- BUZZER - for waking up by buzzer
0 TIME - to set the time
© ALARM 1 - to set alarm time 1
® FAST UP - fast forward
© ALARM 2 - to set alarm time 2
® SLOW DOWN - slow backward
@ RADIO ON/SLUMBER - To switch on the
radio
® CLOCK DISPLAY with ALARM- and PM-
indicator (not for all versions)
® BATTERY Compartment
@ VOLUME control - for adjusting the volume
® TUNING dial - for locating the required station
@ BAND switch - for selecting wavebands
® SLUMBER OFF / REPEAT ALARM button;
- To switch off alarm temporarily
- To switch off the radio
MAINS CONNECTION
Check if the mains voltage as shown on the
type plate on the base of the set corresponds
to your local mains supply.
If it does not, consult your dealer or service
organisation.
As soon as you insert the mains plug into the
wall socket, the figures on the display @ will
blinlc. This means that you must set the correct
time.
To disconnect the set from the mains
completely, withdraw the mains plug from the
wall socket.
RADIO ON
• Set the RADIO switch ® to ON.
• Select the waveband using BAND switch iji).
• Select the required station using the TUNING
® knob.
• Adjust the sound level with the VOLUME
switch
RADIO OFF
• Set the RADIO ® switch to OFF.
Aerials
- The AM aerial is built into the appliance. You
may have to adjust the position of the clock
radio slightly for better reception.
- For FM reception, there is an aerial wire at the
rear of the clock radio. This wire must be
extended and if necessary adjusted slightly in
order to obtain good reception.
CLOCK_________________________________
Clock display
The clock indicates shows the time. The display
also indicates whether you have switched on the
alarm. If alarm 1 is on, the alarm 1 indicator
lights up.
For alarm 2 the alarm 2 •: indicator lights up and
for dual alarm both light up.
Setting the time
• Keep the TIME button ® pressed and set the
correct time as follows:
- Fast forward with the FAST UP ® button.
- Slow backward with the SLOW DOWN button
®.
• Release the TIME button
0
. The correct time
appears in the display.