Philips CD 608 - Manual (Page 8)

OTHER POSSIBILITIES ADDITIONAL INFORMATION
RECORDING FROM YOUR CD PLAYER (EDIT) MAINTENANCE
m
3
<n_
5)'
3 "
In the EDIT mode you can store the tape length
in the player memory. This will then determine
which tracks fit on one side of the tape and a
pause will automatically be inserted after the
last track.
Press EDIT (in STOP mode).
EDIT lights up.
90
lights up under TIME.
With NEXT and PREVIOUS you can now select
the required tape length: 30,46, 60 or 90 min­
utes.
Other tape lengths can be selected using the 1-
0 digit keys.
You can now record the entire CD or a pro­
gramme out of it; the programme must be
stored in advance.
Press PLAY/REPLAY.
The track number indicator shows which num­
bers fit onto side A of the tape; these numbers
will be played one after the other.
Play will stop after the last track.
>starts flashing.
The track number indicator now indicates the
tracks for side B.
Turn the tape over.
Press PLAY/REPLAY.
The remaining tracks will now be played.
NOTE!
- You can also start playback with SHUFFLE;
the numbers will then be recorded in a ran­
dom order.
- As soon as you press PLAY/REPLAY or
SHUFFLE, the other player functions (except
TIME) will temporarily be switched off to pre­
vent the recording being interfered with.
- Should the CD or the programme be longer
than the total tape length, a pause will then
again be inserted after the last track on side
B. The track number indicator then shows
the remaining unplayed track numbers.
The CDs
• Never write on the printed side of a CD.
• Do not attach any stickers to the CD.
• Keep the shiny surface of the CD clean.
Use a soft lint-free cloth and always wipe the
disc in a straight line from centre to edge.
• Never use cleaning agents for conventional rec­
ords.
• Detergents or abrasive cleaning agents should
not be used either.
The player
• A chamois leather slightly moistened with wa­
ter is sufficient for cleaning the player.
• Do not use cleaning agents containing alcohol,
spirits, ammonia or abrasives.
FAULTS AND THEIR LIKELY CAUSES___________
If a fault occurs, run through the points listed be­
low before taking your player for repair. Check
whether:
- condensation has formed on the lens of the
laser due to a dramatic change in temperature;
this will disappear automatically after some
time;
- the C;D has been inserted correctly with the
printed side up and that there is a CD in the
compartment;
- the CD is dirty, badly scratched or warped;
- the player has been connected to the PHONO
socket of the amplifier.
If the fault remains, tiy to clear it by switching the
player off and on again.
If this also fails to help, consult your dealer.
Under no circumstances should you repair
the player yourself, as this will invalidate
the guarantee!
LISTENING WITH HEADPHONES (PHONES)
• Connect headphones with a 6.3 mm jack plug
to the PHONES socket.
- The sound level is adjusted with the VOL(ume)
control.