Philips AJ 3015/04 - Manual (Page 4)

English
WHICH BUTTONS ARE WHERE?___________________
® HOUR button - for setting the hours
@ TIME SET switch:
- TIME - for setting the time
- RUN - normal position
- ALARM - for setting the alarmtime
d) MIN button - for setting the minutes
® ALARM RESET button - to switch off the alarm
for 24 hours
(D
RADIO ON button - to switch on radio function
® ALARM switch:
-
RADIO - for waking up by radio
- BUZZER - for waking up by buzzer and radio
- OFF - alarm off
@ TUNING dial - for locating the required station
(D
BAND switch - for selecting wavebands
(D
VOLUME control - for adjusting the volume
® RADIO OFF / REPEAT ALARM button:
-
To switch off alarm temporarily
- To sviiitch off the radio
(y) Clock display with ALARM- and PM- indicator
® VOLTAGE selector (not on at! versions)
@ BRIGHTNESS HIGH/LOW switch
MAINS COIMNECTIOIM__________________________
The clock radio is suitable for connection to a 220-
230 V / 50 Hz power supply (for Great Britain 240 V /
50 Hz).
If the set is equipped with a VOLTAGE se­
lector, set this selector to the local mains voltage.
As soon as the power plug is put into the wall
outlet, the numbers on the display will start to flash.
This means that you must set the correct time.
To disconnect the set from the mains completely,
withdraw the mams plug from the wall outlet.
RADIO ON
Important notes for users in the U.K.:
Mains plug
Tms ¿cpsraTus is fitte j '.\iTh an ai:,oroveci mou'ded 13 Amp p' jo
To change a fuse m-th'S T.pe of plug proceed as fo"0’.* *.s
1 Remove fu:e co.er acd fuse
2 Ri. nt’.v fuse '.'.h'ch shou'd te a 8S1362 5 A’v’R ,A S T A or
8$l approved typi
3 Refit the fuse co.er
if the fitted plug IS not suitab'e tor ',our see- et outlets, it
shou'd te cut oTt and an apprognate plug fitted in its p'ace
If tne mams plug contains a fuse, this shou'd have 3 va'ue of 5
A If 3 p'ug v.ithput a fuse is used, the fuse at the oistr'butmn
t oird st' ould not be greater than 5 A
Note:
Tnc severed p'ug rr,ust te disposed off to avo d a poss ble
she;' i'Bzard shou'd ii te nsorted into a 13 A see* et eise.vhere
How to connect a plug
Tne Wires m the mams lead are co'oured m accordance v.ith
the fol'o.-.mg cede blue = neutral (N), brown = live iL)
As those co'ours n'>5v not correspond with the colour markings
ic'cntifying the terminals in your p'ug, proceed as fc''0v-.s
1 Connect the b'ue wire to the terminal marked M O'" co'oured
blue or b'ac'-.
2 Connect the bmu n w.re to the term nal marked L or
co'oured bro.'.n cr red
3 Do not ccnrect either w.re to the earth termma! in the p'ug,
msikedEor ^ O'-co'oured green O'green-and-yellow
Befoie rtp'acmiQ the plug cover ma'-.e ce.'tam that the cord
gnp IS c'amped O'.er the sheath of the lead - not simply o.er
the t.vo V'lres
If m doubt, consult a qualified electnc'sn
You may use this clock radio simply as a radio.
• Set the TIME SET switch @ to RUN.
• Press RADIO ON button ® to switch the radio on.
After 59 minutes the radio v/ill be switched off
automatically.
• Select the waveband using the BAND switch @.
• Locate the required transmitter using the
TUNING dial®.
• Set the volume using the VOLUME switch @).
RADIO OFF
You can switch off the radio before the slumbertime
{59 minutes) has elapsed:
• Press the RADIO OFF button
CLOCK
Clock display
The clock indicates the time on the display. In case
of 12-hour clock system, the PM-indicator will light
up (on=PM, off=AM). The ALARM indicator lights
up when you switch on the alarm.
The luminous intensity of the display figures can
be adjusted with the BRIGHTNESS HIGH/LOW
switch ®.
Adjusting the time
• Set the TIME SET sw'itch @ to TIME
• Set the correct time using the MINUTE ® and
HOUR ® buttons.
• Set the TIME SET switch @ to RUN.
ALARM____________________________________
Alarmtime
• Set the TIME SET switch @ to ALARM.
• Set the correct alarmtime using the MINUTE @
and HOUR ® buttons.
• Set the TIME SET switch @ to RUN.
ALARM ON________ ________________________
The clock radio can 'vake you up in 2 ways-
Wake by radio
• Make sure the volume of the radio is loud
enough to wake you.
• Set ALARM switch ® to RADIO.
• You will be woken by the radio at the set alarm
time.
Wake by buzzer and radio
• Set ALARM switch ® to BUZZER.
• At the set alarm time you will be woken up by
the buzzer and the radio.