Improving the radio reception, Basic functions radio – Philips AZ8075 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BASIC FUNCTIONS
RADIO
m
3
os'
Switching on and off/standby
• Set the POWER selector to the desired sound source:
CD-TAPE/OFF-RADIO.
• The set is switched off when the POWER selector is in position
TAPE/OFF and the recorder keys are released.
lO'
• In order to switch off the power supply, remove the mains plug.
Note: When operating the set with batteries, always be sure to
set the POWER selector to position TAPE/OFF when the set is not
used This will avoid a permanent power consumption.
'
1
'
Adjusting volume and sound
• Adjust the sound using the controls VOLUME and DBB and
INCREDIBLE SURROUND.
• Use the rotary knob to in- or decrease the phenomenal stereo
sound. The surround effect varies from 0% to 100%.
' ,
(j) \
• The bass frequencies can also be emphasised if you place the set
against a wall or bookshelf. (Do not cover any vents and leave
sufficient room around the unit for ventilation.)
RADIO - tuning to radio stations
1 Set the POWER selector to RADIO.
2 Select the wave band by using the selector FM MW-LW.
3 Tune to the desired radio station by using the TUNING knob.
Improving the RADIO reception
For
FM,
puli out the telescopic antenna. To improve the FM
signal, incline and turn the antenna. Reduce its length if the
signal is too strong (very close to a transmitter).
For
MW/AM
and
LW,
direct the built-in antenna by turning the
whole set. The telescopic antenna is not needed.