Desa Tech CSPBNT EN - Manual (Page 7)

www.desatech.com 111487-01D 7
Ventilation Air From Outdoors
Provide extra fresh air by using ventilation grills or
ducts. You must provide two permanent openings:
one within 12" of the ceiling and one within 12"
of the floor. Connect these items directly to the
outdoors or spaces open to the outdoors. These
spaces include attics and crawl spaces. Follow the
National Fuel Gas Code, ANSI Z223.1/NFPA 54,
Section 5.3, Air for Combustion and Ventilation for
required size of ventilation grills or ducts.
IMPORTANT:
Do not provide openings for inlet
or outlet air into attic if attic has a thermostat-
controlled power vent. Heated air entering the attic
will activate the power vent.
AIR FOR COMBUSTION
AND VENTILATION
Continued
Figure 2 - Ventilation Air from Inside
Building
Or
Remove
Door into
Adjoining
Room,
Option
3
Ventilation Grills
Into Adjoining Room,
Option 2
Ventilation
Grills
Into Adjoining
Room,
Option 1
12"
12"
Figure 3 - Ventilation Air from Outdoors
Outlet
Air
Ventilated
Attic
Outlet
Air
Inlet
Air
Inlet Air
Ventilated
Crawl Space
To
Crawl
Space
To Attic
UNPACKING
1. Lift off corrugated box enclosing stove
body crating.
2. Remove screws fastening back and top of wood
frame enclosure. Two or more people must care-
fully lift stove up and out of wooden crate.
3. Remove plastic bag from stove body.
4. Remove back panel from stove (see Figure 4).
Use an adjustable wrench or a 10 mm socket.
Remove four (4) bolts and washers. Keep bolts
and washers to reattach back panel later.
5. Remove bubble-wrapped log set, rod and
screen from stove. Remove all protective
packaging applied for shipment.
6. Check all items for any shipping damage. If
damaged, promptly inform dealer where you
bought heater. Some fiber flakes may fall from
logs. This is acceptable.
7. Place freestanding stove near desired location
in room.
Figure 4 - Unpacking Stove from Wooden
Shipping Enclosure
Back
Panel
Screws
STOVE BACK
STOVE TOP
Top of Wood
Frame Enclosure
Back of Wood Frame Enclosure
Back
Panel
Screws