Philips G380-60 - Manual (Page 10)

Cleaning
I Do not use water or a moist cloth to clean the
Groomer.
► Always switch Groomer OFF before cleaning.
K Do not use compressed air, abrasive cleaning
agents, scourers or liquids such as alcohol,
benzene, bleach or acetone to clean the
Groomer and attachments.
► Never clean, replace or remove Groomer
attachments with motor ON.
K Do not apply pressure to cutters.
►
Do not touch cutters with hard objects as this
may damage them.
I Do not use while bathing, showering or
immerse the Groomer in water or other
liquids as damage to Groomer may occur.
During Use:
► If cut hairs have accumulated in the Guide
Comb area, remove hairs by shaking, blowing
or using cleaning brush provided. Remember
to adjust the trimming length back to your
selected setting when you replace the comb on
Groomer.
After Each Use:
D
Make sure the Groomer is switched OFF
and disconnected from the electrical outlet.
u Remove any attachment.
u Also separate the top part of the mini
shaver attachment from its body (fig. 26).
□ Blow and/or shake out any hair that may
have accumulated in the attachment.
► The shaving foil is very delicate and should not
be handled.
► If foil becomes damaged, replace it. Do not
apply pressure to shaving foil.
► Do not clean the foil with the brush, as this
may cause damage.
B Place the attachment back on the Groomer.
Rinsable Attachments
► If preferred your Groomer trimming
attachments (See Features©) can also be
rinsed clean after each use.
n Remove any attachment from Groomer and
rinse attachment only thoroughly under
warm tap water (fig. 27).
Never rinse attachments that are still attached to
the Groomer
a Shake excess water from attachment (fig. 28)
and allow to dry thoroughly.
Do not use a towel to dry the mini shaver as
damage to the shaving foil could occur
B Place the attachment back on the Groomer.
This Groomer has no other user-serviceable parts.
For assistance call I -800-243-3050.