Philips G380-60 - Manual (Page 11)

Storage
► Be sure Groomer is turned OFF. Remove cord
from outlet and Groomer before storing in a
safe, dry location where it will not be crushed,
banged, or subject to damage.
K Do not wrap cord around Groomer when
storing.
► Store cord in a safe location where it will not
be cut or damaged.
I Do not place or store Groomer where it can
fall or be pulled into a tub or sink, water or
other liquid while plugged in.
Replacing Trimmer Cutting Unit
If vour cutters become damaged or worn, do not
continue using the Groomer Call I-800-243-B050
for assistance.
Replacing The Mini Shaver Foil
If the shaving foil is worn or damaged, do not
continue using the appliance. Replace the shaving
foil immediately.
A worn or damaged shaving foil should only be
replaced with an original Philips shaving foil. Visit
www.philips.com/support or call I -800-243-3050
for assistance.
D
Remove the detachable shaving head by
pulling it from the appliance (fig. 26).
a Remove the shaving foil by pushing it out of
the shaving head (fig. 29).
D
Place the new shaving foil carefully in the
shaving head (fig. 30).
□ When the shaving foil is properly positioned,
push it into its end position with your finger
(fig. 31).
Replacing The Mini Shaver Cutter
If the mini shaver cutter is worn or damaged, do
not continue using the appliance. Replace the mini
foil cutter and the shaving foil immediately.
A worn or damaged mini shaver cutter should
only be replaced with an original Philips cutter
Visit www.philips.com/support or call
I -800-243-3050 for assistance.
II
Remove the detachable shaving head by
pulling it from the appliance (fig. 26).
B Remove the old mini shaver cutter by pulling
it from the appliance (fig. 32).
B
Make sure that the spring within the driving
unit does not get lost.
□ Insert the new mini shaver cutter carefully
into the driving unit (fig. 33).
B When the mini shaver cutter is properly
positioned, push it into its end position with
your finger.
B Replace the detachable shaving head on the
appliance or place it in the storage stand.