Philips G380-60 - Manual (Page 9)

Clipping with hair comb attachment
II
Put the hair clipper comb on the full width
trimmer attachment and push until you hear
it‘click’ into place (fig. 17).
Q Press the Hair Length Selector and slide it to
the desired setting. See Table 2.
B The setting selected will appear in the
window to the left of the Hair Length
Selector (fig. 18).
When you are clipping for the first time, start
at the maximum clipping length setting (#9)
to familiarize yourself with the appliance and
prevent accidentally trimming hairs too short. As
you become familiar with the settings, adjust the
Hair Length Selector to desired trimming length.
Selector will ‘click’ into position at each setting.
Table 2. Hair Clipper
Setting Remaining hair length
(in) /(mm)
1 5/32 iny4mm
2 1/4 iny6mm
3 5/16 inySmm
Kt 13/32 inVIOmm
5 15/32 inyi2mm
6 9/16 in/14mm
7 5/8 in./16mm
8 23/32 inyiSmm
9 25/32 iny20mm
D Make sure that the flat part of the comb is
always in full contact with the scalp to obtain
an even result (fig. 19-20).
B
Move the appliance slowly over the crown
from different directions to achieve an even
result (fig. 21).
Q Always move the appliance against the
direction of hair growth.
B Make overlapping passes over the head to
ensure that all hair that should be cut has
been cut.
B
Turn the Groomer off and remove the hair
comb often to blow and/or shake out hair
that has accumulated.
► REMEMBER:You must reset the hair length
selector back to your desired setting every
time you replace the hair clipping comb on the
appliance.
Contouring without the hair clipping
comb attachment
D Remove the hair comb by pressing and
sliding the Hair Length Selector upwards
(fig. 22).
Be careful when you are clipping without comb
attachment as when the appliance is turned on it
will trim every hair it touches.
B
Tilt the appliance in such a way that only
one edge of the trimming attachment
touches the hair ends when you shape the
contours around the ears (fig. 23).
Q To contour the nape of the neck or hairline,
turn the appliance and hold it with the
trimming attachment pointing downwards
(fig. 24).
□ To contour the sideburns, turn the appliance
and hold it with the trimming attachment
pointing downwards (fig. 25).