Cisco SPA 2100 User Manual
Page 2
2
Installing the NationPhone Router & Phone Adapter SPA2100
1.
Power off your DSL or cable modem and computer.
2.
Insert an Ethernet cable into the WAN port. Connect the other end of an Ethernet cable
into your DSL or cable modem.
3.
Insert an end of another Ethernet cable into the LAN port. Connect the other end of the
Ethernet cable into the Ethernet port on your computer.
4.
Insert the line from your telephone handset into the PHONE 1 port of the NationPhone
Router & Phone Adapter. Connect the other end of the telephone cable to a traditional
analog telephone.
5.
Apply power to your DSL or cable modem. Ensure the proper status indicators are lit.
6.
Plug the power adapter into the NationPhone Router & Phone Adapter. The yellow STAT
light will blink for up to one minute. When complete the yellow STAT light and the green
light will remain solid.
7.
If you wish, you may power up your computer now. Your computer does not need to be
on in order to make calls.
8. You can now make calls! Pick up the phone receiver and listen for a dial tone. If you do
not have a dial tone, refer to the troubleshooting portion of this document.