2 installation of second upright and end fitting, 4 adjust end fitting to high school position – Jaypro Sports FBGP-920AX User Manual

Page 13

Advertising
background image

WWW.JAYPRO.COM

P a g e

13 11/1/13


9. Insert a 1/2-13 x 7.5-inch-long hex head bolt through the hole in the crossbar

and end fitting. Install two 1/2-inch washers and 1/2”-13 nut and tighten.

8.2

Installation of Second Upright and End Fitting

1. Repeat steps 1 through 9 of section 8.1 above for the other end fitting and

upright.


2. Confirm level of crossbar and plumbness of both uprights, adjust as necessary.

3. Drill second hole in end fitting in manner described above, using the other hole

in crossbar as a guide.

4. Install 1/2-13 x 7-1/2” hex bolt, washers, and nut.

5. Confirm level of crossbar and plumbness of both uprights, adjust as necessary.

6. Drill second hole in upright insert in manner described above, using the

remaining hole in upright as a guide.


7. Install 1/2-13 x 5” hex bolt into hole.

8.3

Complete Installation of First Upright and End Fitting

1. Confirm level of crossbar and plumbness of both uprights, adjust as necessary.

2. Repeat steps 3 through 7 in section 8.2 above for other upright and end fitting.

3. Tighten all bolts in end fittings and uprights as much as possible.

8.4

Adjust End Fitting to High School Position.

1. Working with one end fitting at a time, remove the 7 ½ in bolts that were

installed to lock the end fitting into place at the College position.

2. Pull the end fitting out so that the inside of the upright measures 34 inches to

the outer end of the crossbar (See Figure 8). Note that the anti rotation bolt will
hold the upright vertical but the end fitting will go out further than the 34 inches.

a. Use a rubber mallet if necessary to get the end fitting started or to make

small adjustments.

Advertising
This manual is related to the following products: