Jaypro Sports FBGP-820AX - Manual (Page 24)

WWW.JAYPRO.COM Page 24 11/1/13
12.2 Installation of Second Upright and End Fitting
1. Repeat steps 1 through 9 of section 12.1 for the other end fitting and upright.
2. Confirm level of crossbar and plumbness of both uprights, adjust as necessary.
3. Drill second hole in end fitting in manner described above, using the other hole
in crossbar as a guide.
4. Install 1/2-13 x 7-1/2” hex bolt, washers, and nut.
5. Confirm level of crossbar and plumbness of both uprights, adjust as necessary.
6. Drill second hole in upright insert in manner described above, using the
remaining hole in upright as a guide.
7. Install 1/2-13 x 5” hex bolt into hole.
12.3 Complete Installation of First Upright and End Fitting
1. Confirm level of crossbar and plumbness of both uprights, adjust as necessary.
2. Repeat steps 3 through 7 in section 12.2 above for other upright and end fitting.
3. Tighten all bolts in end fittings and uprights as much as possible.
12.4 Adjust End Fitting to High School Position.
1. Working with one end fitting at a time, remove the 7 1/2 in bolts that were
installed to lock the end fitting into place at the College position.
2. Pull the end fitting out so that the inside of the upright measures 34 inches to
the outer end of the crossbar (See Figure 13). Note that the anti rotation bolt
will hold the upright vertical but the end fitting will go out further than the 34
inches.
a. Use a rubber mallet if necessary to get the end fitting started or to make
small adjustments.
3. Check that the upright is still plumb once at the 34 inch position. Follow the
procedures in Section 12.1 Steps 8 and 9 to install the 7 1/2 inch long bolts at
the High School position.