Fluid level check – 5.7l engine – Jeep 2013 Grand Cherokee User Manual

Page 640

Advertising
background image

CAUTION!

If a transmission fluid leak occurs, visit your au-

thorized dealer immediately. Severe transmission
damage may occur. Your authorized dealer has the
proper tools to adjust the fluid level accurately.

Fluid Level Check – 5.7L Engine

It is best to check the fluid level when the transmission is
at normal operating temperature (approximately 180°F /
82°C). This occurs after at least 15 miles (25 km) of
driving. At normal operating temperature the fluid can-
not be held comfortably between the fingertips.

Use the following procedure to check the fluid level
properly:

1. Park the vehicle on level ground.

2. Run the engine at idle speed and normal operating

temperature.

3. Fully apply the parking brake, and press the brake

pedal.

4. Place the shift lever momentarily into each gear posi-

tion (allowing time for the transmission to fully en-
gage in each position), ending with the shift lever in
PARK.

5. Remove the dipstick, wipe it clean and reinsert it until

seated.

6. Remove the dipstick again, and note the fluid level on

both sides. The fluid level reading is only valid if there
is a solid coating of oil on both sides of the dipstick.
The holes in the dipstick will be full of fluid if the
actual level is at or above the hole. The fluid level
should be between the

ЉHOTЉ (upper) reference holes

on the dipstick at normal operating temperature. If the
fluid level is low, add fluid through the dipstick tube
to bring it to the proper level. Do not overfill.

638

MAINTAINING YOUR VEHICLE

Advertising