Problem, Specifications, Troubleshooting – Philips MC10537 User Manual
Page 20: Problem solution
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Specifications
AMPLIFIER
Output power..................................... 2 X 5 W RMS
.................................................. 10 W total power
Signal-to-noise ratio.......................> 65 dBA (lEC)
Frequency response......... 40 - 20000 Hz, + 3 dB
Input sensitivity AUX......................0.5 V (max. 2V)
Impedance loudspeakers................................... 8 П
Impedance headphones.................. 32 Q -1000 ,Q
CD PLAYER
Frequency range............................ 20 - 20000 Hz
Signal-to-noise ratio.................................... 75 dBA
TUNER
FM wave range............................. S7.5 - 108 MHz
AM wave range............................. 530 - 1700 kHz
Sensitivity at 75 £2
- mono, 26 dB signal-to-noise ratio.............. 2,8 pV
- stereo, 46 dB signal-to-noise ratio........... 61.4 pV
Selectivity.................................................... > 28 dB
Total harmonic distortion................ :................< 5%
Frequency response...... 63 - 12500 Hz (± 3 dB)
Signal-to-noise-ratio.................................> 50 dBA
TAPE DECK
Frequency response
Normal tape (type I)... 120 - 10000 Hz (8 dB)
Signal-to-noise ratio
Normal tape (type I)................................ 48 dBA
Wow and flutter.................................... < 0.4% DIN
SPEAKERS
Bass reflex system
Dimensions (w x h x d). 155 x 220 x 210 (mm)
...................................... 6.1 Ox 8,66
X
8.26 (inch)
GENERAL INFORMATION
»s
AC Power.......................................... 1 2 0 V / ^ 0 H z
Dimensions (w x h x d) .. 140 x 223 x 253 (mm)
...................................... 5.51
X
8.78
X
9.96 (inch)
Weight (with/without speakers).......................... .......
................................................ approx, 6.0 / 2.8 kg
....................................approx. 13.2 / 6,16 pound
Standby power consumption......................... <t 3 W
Subject to modification
Troubleshooting
WARNING
Under no circumstances should you try to repair the system yourself, as this will invalidate the
warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If you
are unable to remedy a problem by following these hints, consult your dealer or service center.
Problem
Solution
CD OPERATION
’ is displayed.
Insert a disc.
Check if the disc is inserted upside down.
Wait until the moisture condensation at the lens
has cleared.
Replace or clean the disc, see "Maintenance".
Use a finalized CD-RW or CD-R.
20