Cobra Electronics XRS 989 - Manual (Page 5)

Installation
Your Detector
Nothing Comes Close to a Cobra ® 5
Installation
Your Detector
4 English
1. Attach the rubber
cups to the bracket.
3. Push the bracket firmly onto
the windshield.
4. Attach the detector to
the bracket. Check that
the unit is parallel to the
road’s surface.
5. To adjust the angle if
necessary, gently push or pull
on the bracket to bend it. DO
NOT use the detector to bend
6. Plug the power cord
into the detector.
7. Plug the cigarette lighter
adapter on the power
cord into your vehicle’s
cigarette lighter.
8. You can temporarily remove the detector whenever you
wish by depressing the bracket release button and sliding
Windshield Mounting
1. Place the detector on the dashboard to find a location
where the unit has a clear, level view of the road and is parallel
to the road’s surface. The angle CANNOT be
2. Remove the paper backing
from one side of the hook-
and-loop fastener.
3. Attach the pad to the
dashboard at your chosen
location and remove the
other paper backing.
4. Attach the detector to the
hook-and-loop fastener.
You can remove and reattach
the unit as
5. Plug the power cord
into the detector.
6. Plug the cigarette lighter
adapter on the power
cord into your vehicle’s
cigarette lighter.
Dashboard Mounting