Kenton Killamix Mini - Manual (Page 6)

6
On – two modes are available indicated by the LEDs lit on the ledring above button 2
1 – four pole mode with centre zero (CCs 19,20,21,22) sending analogue values 0 –127
2 – four pole mode switching joystick (CCs 19,20,21,22) only value 127 sent at limits
When in 4 pole mode, the centre position is zero, and moving right sends CC#19, up sends
CC#20, left sends CC#21 and down sends CC#22.
Button 3 – Receive CCs for Encoders and Push buttons
Off = incoming MIDI messages ignored (default)
On = two modes are available indicated by the LEDs lit on the ledring above button 3
1) Allow received CCs to update Encoder and Push button values for all channels.
This mode updates ALL CCs on ALL channels – even if that channel is not the one currently
selected, however note the following exception:
For push buttons, only buttons set to toggle mode will be updated because this is the only
mode that can be meaningfully used. Push buttons set to on-only or on-off modes will still
operate as usual but will not be updated by received CCs.
2) Allow received CCs to update Encoders
Allow received CCs (or Notes if selected) to update push button LEDs *ONLY*
Push button LEDs are not directly updated from the buttons.
Works for all 3 button modes – on only / on-off / toggle
Button 4 – Hi-Speed Encoder mode
Off = normal 3 speed operation (default)
On = hi-speed mode active
Hi-Speed mode is implemented so that turning the encoder VERY slowly will still increment or
decrement slowly, but anything faster will operate at hi-speed.
Button 5 – Buttons send MIDI notes
Off = buttons send controllers (CCs 10 - 18) as standard – (default)
On = push buttons send MIDI notes instead of controllers
There are 4 active modes which are indicated by the LED-ring above button 5. Where the
following LEDs are lit, modes are as follows:
1) Impulse mode for Ableton drums - buttons are mapped to white keys only from middle C
(MIDI note #60)
2) Consecutive mode (white & black keys) starting from MIDI note #36
3) Consecutive mode (white & black keys) starting from MIDI note #48
4) Consecutive mode (white & black keys) starting from MIDI note #60
Remember to set the individual buttons to their on/off mode if you want to send note-offs when
you release the buttons.
Button 6 – Knobs pressed send controller messages mode (instead of changing channel)
Off = Knobs pressed change MIDI channel (default)
On = The selected modes are indicated by the LED-ring above button 6.
The LED ring above button 6 indicates the mode:
1) Knobs send controllers 24-32 with value 127 when pressed (nothing when released)
2) Knobs send controllers 24-32 with value 127 when pressed and with value 0 when released