Kenton Killamix Mini - Manual (Page 7)

7
As single knob presses no longer change MIDI channel – you can change MIDI channels in
this mode by using knob 9 plus one of knobs 1-7, this means that you can now only select
channels 1 to 7 in this mode.
Pressing knobs 9+8 still allows you to set button modes as usual.
Button 7 – Offset controller numbers (does not affect Note numbers if selected)
Off = Controller numbers (CCs) are as standard (default)
On = Controller numbers are offset by the following amounts indicated by which LED of the
ledring is lit:
1) offset by 10 – knobs go 11 to 19 – buttons 20 to 28 – joystick 29/30 [/31/32]
2) offset by 20 – knobs go 21 to 29 – buttons 30 to 38 – joystick 39/40 [/41/42]
3) offset by 30 – knobs go 31 to 39 – buttons 40 to 48 – joystick 49/50 [/51/52]
4) offset by 40 – knobs go 41 to 49 – buttons 50 to 58 – joystick 59/60 [/61/62]
5) offset by 50 – knobs go 51 to 59 – buttons 60 to 68 – joystick 69/70 [/71/72]
6) offset by 60 – knobs go 61 to 69 – buttons 70 to 78 – joystick 79/80 [/81/82]
7) offset by 70 – knobs go 71 to 79 – buttons 80 to 88 – joystick 89/90 [/91/92]
8) offset by 80 – knobs go 81 to 89 – buttons 90 to 98 – joystick 99/100 [/101/102]
9) offset by 90 – knobs go 91 to 99 – buttons 100 to 108 – joystick 109/110 [/111/112]
Button 8 – currently undefined
Knob 9 (not button) – last push button lights button LED mode
When ledring 9 is all off, mode is inactive and LEDs operate normally.
When ledring 9 LED #1 is lit, mode is active [on].
When on, the last square push button pressed (or released) indicates which button was
pressed last.
If you change MIDI channels then all button LEDs go out until a button is pressed on this
channel.
The current on/off state of the button is not indicated in this mode.
Button 9 – Exit this mode – saves the settings and exits to normal operational mode.