Kenton USB-Solo User Manual

Page 10

Advertising
background image

10

P 40

Continue = start - (default: on)

[note - default was off before firmware 1007]

The following can be selected:
Off

[oFF]

On

[ on]

- when set to on, all continue messages are treated as if they were MIDI start messages.
- when set to off, continue messages will only be treated as start if immediately preceded by a song
position pointer = zero message. Some sequencers use this instead of a start message.
Affects both the sync 24 output and aux output when in clock mode.

P 41

Clock divide ratio - (default: 2)


available values c24, c48 & d2 to d24,
- sets the ratio of MIDI clocks to output pulses from the aux3 output set to clock mode

c24 – special drum machine mode – outputs 24 cpqn – used for many drum machines
c48 – special drum machine mode – outputs 48 cpqn – for Linn & Oberheim drum machines
N.B. Some drum machines use other values e.g. the Roland CR78 uses 12 cpqn (div ratio 2)

If set to 2, there will 12 pulses from the aux output for every 24 MIDI clocks = 12 cpqn
If set to 24, there will be 1 pulse from the clock pulse output for every 24 MIDI clocks = 1 cpqn
(Note there are 24 MIDI clocks per quarter note)

Below is a table of values you can set the divide ratio to in order to obtain a clock pulse at various
musical time intervals:-

Note type

Divide ratio

CPQN (clocks per quarter note)

Crotchets

(quarter notes) 24 1

Crotchet triplets 16
Quavers

(eighth notes)

12 2

Quaver triplets

8

Semiquavers

(sixteenths) 6 4

Semiquaver triplets 4 6
Demisemiquavers 3 8
Demisemiquaver triplets

2 12

P 42

AUX 2 controller number (default: 18)

- Sets which MIDI controller will control AUX2 output
The following controllers can be selected:

Clock Stop/Start

[S t t]

Off

[oFF]

Pitch bend

[Pbd]

Velocity

[VEL]

Aftertouch

[AF t]

MIDI controllers

0-119


Note that this is a switch output and will be 0 volts or 5 volts depending on the MIDI data value and the
threshold setting below.


P 43

AUX 2 threshold (default: 64)

Range

1 to 127

- Sets the threshold at which the AUX2 output will change from 0 to 5V or from 5V to 0.

If the MIDI data value of the selected controller is greater than or equal to the threshold then AUX2 will
be on (5V), otherwise it will be off (0V).

Note: Does not affect Clock Stop/Start

Advertising