Kenton Pro-Solo mk1 - Manual (Page 17)

Only synths that have the appropriate inputs can be controlled from a MIDI-
CV converter.
The synth needs some sort of CV and GATE inputs.
CV`s may be labelled CV In, OSC In, Keyboard In, VCO In, Key Volt, etc.
GATEs (and S-TRIG) may be labelled GATE In, S-TRIG, V-TRIG (voltage trigger, same as
gate), Trig In, etc.
Any additional inputs may be utilised, like Filter, VCF fcM, VCF, PORTA (portamento),
Loudness, VCO, PWM, etc. by using the converter’s AUX output.
Some synths that cannot be connected to a MIDI-CV converter via CV, GATE, AUX
Outputs (as they do not have them);
OSCAR Kenton can do an internal MIDI retrofit
EDP WASP Possible with a PRO 2000 (with WASP port)/ PRO-4/PRO-KADI
100P Applies to most other preset synths/mono. string machines
Power Input 9-15V DC (regulated supply recommended)
Power 100mA, 2.1mm plug (centre negative)
MIDI In, Thru
Analogue outputs CV (V/oct or Hz/V)
Gate (Gate or S-trig)
Aux
Weight 450g
Dimensions 130 x 97 x 40 mm
D to A conversion 2 x 16 bit
Non-volatile memoryEEPROM (no back-up battery required)
WARRANTY
The PRO SOLO comes with a 12 month (from purchase date) back to base warranty, (i.e.
customer must arrange and pay for carriage to and from Kenton Electronics).
Brookfarm House, Station Road, South Wimbledon, London, SW19 2LP, UK
Tel: +44 (0)20 8544 9200 Fax: +44 (0)20 8544 9300
e-mail:[email protected] www:http://www.kenton.co.uk
rev# 4300_086 e. & o. e.  18 TH January 2003
SPECIFICATIONS