Kenton Pro-2 - Manual (Page 3)

For example, supposing the display reads " - 7 "
if the dash is at the bottom, this means 107
if the dash is in the middle, this means 117
if the dash is at the top, this means 127
No values above 127 are used.
The two dots at the top of the display indicate when the gates of Channels A or B are active.
_________________________________________________________________
THE PUSH BUTTONS
_________________________________________________________________
SELECT OPTION
Press and release the SELECT OPTION push button and the bargraph display will move on to the next
position. The legend to the right of the bargraph will tell you what the dual 7 segment display is
showing - this can be edited using the INC & DEC buttons.
When you step the display on from "aux B-2 offset" you will see that the bargraph is inverted - in other
words, all but one of the bars will be lit. This unlit bar is then the
current option, but from the second
group of options "GROUP II" which starts with "note priority A." If you keep stepping through past
"continue=start" you will come back to the original non-inverted display, or in other words "GROUP I".
When you have edited something you can use the new settings until the converter is turned off, or
you can store them to back-up memory so that they will be recalled when the converter is next
turned on. When you store to back-up memory, the whole current setup is stored, not just the option
you have just edited.
To store to back-up memory press and hold the SELECT OPTION button until "st"
appears in the display window. The present setup has then been stored.
Note; If you have edited the current option, the bar will not step the first time you press the select
button after editing.
INC & DEC
Use the INC and DEC push buttons to edit the display and hence the option that is currently selected.
If you hold either button in for more than a second, it will auto-repeat. when the displayed option has
reached its minimum or maximum value you cannot decrease or increase it any further.
The INC and DEC buttons can be used while MIDI notes etc. are being received.