Kenton GS-8 - Manual (Page 13)

ddd = 011 = memory dump
[ 7] 000000bb - where bb = memory area as per info request
[ 8] 00yyyyy - where yyyyy = number of bytes
[ 9] 0000xxxx - where xxxx = low 4 bits of data
[10] 0000zzzz - where zzzz = high 4 bits of data
Note that bytes 9 & 10 are repeated the number of times specified in 8.
[11] 0xxxxxxx - where xxxxxxx = the lowest 7 bits of the CRC
[12] 0yyyyyyy - where yyyyyyy = the middle 7 bits of the CRC
[13] 000000zz - where zz = the highest 2 bits of the CRC
[14] F7h - end of exclusive
______________________________________________________________
ddd = 100 = switch `Thru` to `Thru`
[ 7] F7h - end of exclusive
Restores the MIDI Thru socket to a `Thru` of the incoming data.
______________________________________________________________
ddd = 101 = switch `Thru` to `Out`
[ 7] F7h - end of exclusive
Switches the MIDI Thru socket to become a MIDI Out.
Note that no incoming MIDI is transmitted via the `Thru` socket once this command has been
accepted.
______________________________________________________________
ddd = 110 = direct system control
[7] controls the system directly as follows;
00h = Bypass off 20h = Bypass on
01h = Pedal#1 off 21h = Pedal#1 on
02h = Pedal#2 off 22h = Pedal#2 on
03h = Pedal#3 off 23h = Pedal#3 on
04h = Pedal#4 off 24h = Pedal#4 on
05h = Ped#5 /Amp#D off 25h = Ped#5/Amp#D on
06h = Ped#6/Amp#C off 26h = Ped#6/Amp#C on
07h = Amp#B off 27h = Amp#B on
08h = Amp#A off 28h = Amp#A on
09h = Set Pedal#5 as Pedal 29h = Set Pedal#5 as Amp
0Ah = Set Pedal#6 as Pedal 2Ah = Set Pedal#6 as Amp
0Bh = Set Amp#B as Latch 2Bh = Set Pedal#B as Mom
0Ch = Set Amp#A as Latch 2Ch = Set Pedal#A as Mom
0Dh = Set display to `Patch` 2Dh = Set display to `Chan`