Keri Systems SM-2000 - Manual (Page 3)

IntelliProx – SM-2000
2305 Bering Drive 01830-003 Rev. H
San Jose, CA 95131 USA
(800) 260-5265 (408) 435-8400 FAX (408) 577-1792
Web: www.kerisys.com E-mail: [email protected]
Page 3 of 10
IntelliPr
o
x
Quick S
tart Guide
3.0 Cautions
An IntelliProx must have clean power to ensure best operating conditions. Regulated, linear power supplies are
recommended. Switching power supplies and rectified AC power supplies cannot be used as they are known sources for
radiated electromagnetic interference that affects IntelliProx operation.
When using the IntelliProx in place of standard proximity readers ensure that Keri KC-26 (or compatible) 26-bit cards
are used. The use of alternate format cards will not output a proper 26-bit identification number to the host system,
making card enrollment difficult if not impossible.
A jumper is available for resetting the IntelliProx's PIN and memory. The IntelliProx will not operate if JP1 is
installed; JP1 must be removed for normal system operation. If JP1 is installed and power is applied to the IntelliProx,
the PINs are reset to the factory default values and to the Dual-Line LED control configuration. If power is applied
again with JP1 still installed, all information in system memory is erased and cannot be recovered unless it had been
previously uploaded to a data file stored by the D-Lite program.
Figure 1: The IntelliProx SM-2000