Cadillac 2010 Escalade - Manual (Page 266)

3. Say the name tag of the person to call.
. If the system clearly recognizes the name tag it
responds with “OK, calling, <name tag>” and
dials the number.
. If the system is unsure it recognizes the right
name tag, it confirms the name tag followed by
a tone. If the name tag is correct, say “Yes”.
The system responds with “OK, calling, <name
tag>” and dials the number. If the name tag is
not correct, say “No”. The system will ask for
the name tag to be re‐entered.
Once connected, the person called will be heard
through the audio speakers.
Using the Re‐dial Command
1. Press and hold
b g
for two seconds. The system
responds with “Ready” followed by a tone.
2. After the tone, say “Re‐dial”. The system responds
with “Re‐dial using <phone name>” and dials the
last number called from the connected Bluetooth
phone.
Once connected, the person called will be heard
through the audio speakers.
Receiving a Call
When an incoming call is received, the audio system
mutes and a ring tone is heard in the vehicle.
. Press
b g
and begin speaking to answer the call.
. Press
c x
to ignore a call.
Call Waiting
Call waiting must be supported on the Bluetooth phone
and enabled by the wireless service carrier to work.
. Press
b g
to answer an incoming call when
another call is active. The original call is placed
on hold.
. Press
b g
again to return to the original call.
. To ignore the incoming call, continue with the
original call with no action.
. Press
c x
to disconnect the current call and
switch to the call on hold.
4-74