Kuzma STOGI REF 313 110513 - Manual (Page 4)

2.0.0. Unpacking:
2.1.0. Packing list:
Tonearm with fingerlift; counterweight; armbase; instruction manual; protractor for cartridge
geometry adjustment and a bag containing:
Bag:
Sets of 3 socket head screws M6x16 mm, M6x20 mm, M6x25 (for Stabi Ref), M6x 30 mm,
three washers, three spring washers (wooden armboards) for fixing base.
Allen keys: 5 mm for attaching armbase to armboard, 3 mm for height adjustment
(VTA), 2mm for cartridge and azimuth, 1,5 mm for fixing counterweight, bias and cueing
device adjustment.
Small bag containing 2 headsocket screws M2.5 x 5mm, M2.5x8 mm, M2.5x 12mm and nuts
for fixing cartridge plus Allen key 0.7 mm for removing fingerlift.
Open the box carefully and remove the top cover. Ensure that the armboard on the turntable has
the correct cut-out (main central hole must be 30- 40mm in diameter).
Remove the armbase and prepare it for fixing onto the turntable.
Holding the pillar not the tube, lift the tonearm out. Observe bias and thread while so doing.
The tonearm can be rested upside down on the C shape.
Remove all other parts.
3.0.0. Tonearm Setup:
3.1.0. Armbase Setup:
3.1.1. Armboard cutout:
Take the tonearm mounting protractor and place on spindle of turntable. The Stogi cut-out is
similar to the standard Linn cut-out but with a 300mm pivot to spindle distance.(You can also
use a Kuzma cutout)
Mark the position of holes on the tonearm mounting board as indicated on protractor.
Ensure that there is adequate space in front for tube and headshell and behind for
counterweight, in order to avoid problems of lid closure. Check also that screw
positions will be over the cut-out on subchassis, unless screws are to be sunk. It is wise
before cutting to hold tonearm in position over marks and judge the position of the
tonearm on the board will be correct, bearing in mind these criteria. Otherwise the
precise position of the tonearm is unimportant providing it lies on the protractor arc.
The height of the tonearm with cartridge mounted is 55mm above record.
Remove tonearm board from turntable and check that the thickness of board is between 6 mm
and 22 mm, if so make cuts as marked.
4