Kuzma Stabi XL 2000 - Manual (Page 7)

7
Setting up the turntable:
Tonearm:
Ensure that the supporting stand is completely horizontal. When the Air Line tangential
tonearm is used additional fine adjustment of turntable horizontality is mandatory.
Mount the chosen tonearm according to instructions. Firmly secure the armbase onto the
tonearm top brass plate and secure it with two screws, using Allen key 3 mm, at the side of
the tower. See Fig.2
Fixing screws on top of the tonearm tower.Fig.2.
Raise the tonearm to an appropriate height above the platter. Position the tonearm cable
towards the back of the turntable towards the phono input. Check the length.
Check again the spindle to tonearm distance and rotate tower to be in an optimal operating
position.
VTA Guage:
Hang the digital display on the front of the tonearm tower using the lever and screw at the
bottom of the tower. Ensure that the display does not touch the platter or motor towers. See
Fig. on page 2.
The display can be left in the 'ON' position for up to three years (battery). Pressing 'origin'
will cause 0.00mm to show. Switching to + or – will cause this sign to appear in front of the
numbers. Pressing (press and hold for about one sec) to 'origin' again, resets the display to
zero. Due to the limits of height measurement (12 mm), the display should show the middle
of the measurement. An appropriate height for the tonearm is when the tube is parallel to the
record after the cartridge is mounted.