LABEC J-WD-1 - Manual (Page 5)

Safety Precautions
The following safety precautions must be observed and followed to avoid fire hazard, electrical shock,
accidents, and other failures. Keep them in mind and make sure that all the precautions are observed
and followed properly. Laboratory Equipment Pty Limited. assumes no liability or any responsibility
against any damages, accidents, or problems resulting from negligence of the precautions.
Users
This product must be used only by qualified personnel who understand the contents of this operation
manual. If it is handled by disqualified personnel, personal injury may result.
Be sure to handle it under supervision of qualified personnel.
Purpose of use
If the product is to be used for purposes not described in this manual, contact your LABORATORY
EQUIPMENT PTY LIMITED agent in advance.
Input Power
Use the product with the specified input power voltage. For applying power, use the AC power cable
provided. The shape of the plug differs according to the power voltage and areas. Use the cable which
is suitable for the line voltage used.
Cover
There are parts inside the product which may cause physical hazards. Do not remove the external
cover. If the cover must be removed, contact your LABORATORY EQUIPMENT PTY LIMITED agent in
advance.
Installation
When installing products be sure to observe Installation Precaution described in this manual.
To avoid electrical shock, connect the protective ground terminal to electrical ground (safety ground).
When applying power to the products from a switchboard, be sure work is performed by a qualified and
licensed electrician or is conducted under the direction of such a person. Be sure to use the AC power
cable provided.
Relocation
Turn off the power switch and then disconnect all cables when relocating the product. Use two or more
persons when relocating the product which weights more than 20 kg. The weight of the products can be
found on the rear panel of the product and/or in this operation manual. Use extra precautions such as
using more people when relocating into or out of present locations including inclines or steps. Also
handle carefully when relocating tall products as they can fall over easily. Be sure the operation
manual be included when the product is relocate