Lippert Components Ground Control 3.0 - Manual (Page 18)

Rev: 01.30.2015
Page 18
Ground Control 3.0 Service Manual
Touch Pad Replacement
1. Remove the face plate of the touch pad (Fig. 28A) from the mounting bezel (Fig. 28B).
2. Unplug the harness from the connector on the back of the face plate.
3. Plug the touch pad harness into the connector on the back of the replacement touch pad face plate
and snap the face plate into the bezel.
Fig. 28
A
B
Jack Motor Replacement
1. Using a ½ " socket or wrench, remove the two motor retention bolts from the jack (Fig. 29).
2. Remove the faulty motor from the top of the jack (Fig. 30).
3. Gently position the replacement motor into the coupler found inside the jack.
4. Replace and tighten motor retention bolts.
Fig. 29
Fig. 30