Lippert Components LCI Electronic/Hydraulic Leveling & Slideout - Manual (Page 10)

Rev: 07.14.2014
Page 10
Untitled-1
Manual Leveling Procedure
NOTE: When leveling your coach, the coach should be leveled from FRONT TO REAR first (steps 2-4). When
the coach is level from FRONT TO REAR, then level the coach from LEFT TO RIGHT (step 5).
NOTE: Coach must be running for LCI Electronic/Hydraulic Leveling System to operate.
1. Push ON/OFF (Fig. 5O) button on control panel. The system is now operational and the ON/OFF (Fig.
5O) light will be lit. If ON/OFF (Fig. 5O) light is not lit, see PRIOR TO OPERATION, page 9.
2. Push and hold MAN button (Fig. 5A) for 5 seconds.
3. Push FRONT button (Fig. 5J) until jacks contact the ground.
4. Push REAR button (Fig. 5M) until jacks contact the ground.
5. Push button FRONT or REAR; if bubble is towards front of coach push REAR button; if bubble is towards
rear of coach, push FRONT button. Keep button depressed until bubble is centered.
6. Push LEFT (Fig. 5K) or RIGHT (Fig. 5L) button; if bubble is towards left of coach, push RIGHT button; if
bubble is towards right of coach push LEFT button. Keep button depressed until bubble is centered in
vial.
NOTE: The right and left jacks are used to level the coach side to side. Pushing the LEFT (Fig. 5K) button
on the control panel will extend both left jacks. Pushing the RIGHT button (Fig. 5L) on the control
panel will extend both right jacks. Jacks always work in pairs, both front jacks together, both right
side jacks, etc.
7. Repeat steps 2 through 5 if needed.
8. Turn power off to leveling system by pushing ON/OFF button (Fig. 5O).
9. Visually inspect all jacks to ensure all shoes are touching the ground. Should one of the rear jack shoes
not be touching the ground, press the corresponding LEFT or RIGHT rear jack buttons to lower the
corresponding jack to the ground.
NEVER LIFT ALL THE WHEELS OFF THE GROUND TO LEVEL THE COACH!
Lifting all wheels off the ground may result in death or serious personal injury.
10. Push ON/OFF button (Fig. 5O) to de-energize the system.
Jack Retract Procedures
1. Energize the system by pushing ON/OFF button (Fig. 5O) on control panel. The ON/OFF light will be lit.
2. Push the RETRACT ALL JACKS button (Fig. 5P). All the jacks will start to retract and return to the full
retract position. When all jacks return to full retract position the JACKS DOWN light (Fig. 5F) will go out.
NOTE: If you wish to stop the jacks from retracting, turn the system off and back on again by pushing the
on/off pad twice. You can then re-level the coach by following steps 1-5 again.
3. When the JACKS DOWN light (Fig. 5F) goes out, push the ON/OFF button (Fig. 5O) on the Control Panel
to de-energize the system. After a brief visual inspection around the coach to verify the jacks are fully
retracted, you may proceed to travel.
NOTE: When in the MANUAL mode, if the RETRACT button is pushed the jacks will only retract as long as the
RETRACT button is depressed. In AUTOMATIC mode, the RETRACT button need only be pressed
once and released for the jacks to fully retract.