Lippert Components Ultra Level - Manual (Page 7)

MANUAL LEVELING PROCEDURES
NOTE: When leveling your coach, the coach should be leveled from FRONT TO REAR first (step 2-4). When the coach is level from
FRONT TO REAR, then level the coach from LEFT TO RIGHT (step 5).
NOTE: Coach must be running for LCI Electronic Leveling System to operate.
1. Push ON/OFF button on control panel. The system is now operational and the ON/OFF light will be lit.
2. Push and hold MAN button for 5 seconds.
3. Push FRONT button until jacks contact the ground.
4. Push REAR button until jacks contact the ground.utton. Keep button depressed until bubble is centered.
6. Push LEFT or RIGHT button; if bubble is towards left of coach, push RIGHT button; if bubble is towards right of coach push LEFT
button. Keep button depressed until bubble is centered in vial.
NOTE - The right and left jacks are used to level the coach side to side. Pushing the LEFT button on the control panel will extend
both left jacks. Pushing the RIGHT button on the control panel will extend both right jacks. Jacks always work in pairs,
both front jacks; both right side jacks, etc.
7. Repeat steps 2 through 5 if needed.
8. Turn power off to leveling system by pushing ON/OFF button.
9. Visually inspect all jacks to ensure all shoes are touching ground. Should one of the rear jack shoes not be touching the ground,
press the corresponding LEFT or RIGHT rear jack buttons to lower the corresponding jack to the ground.
WARNING
!
NEVER LIFT ALL THE WHEELS OFF THE GROUND TO LEVEL THE COACH!
Lifting all wheels of the ground may result in serious personal injury or death.
JACK RETRACT PROCEDURES
1. Energize the system by pushing ON/OFF button on control panel. The ON/OFF light will be lit.
2. Push the RETRACT ALL JACKS button. All the jacks will start to retract and returns to the full retract position. When all jacks return
to full retract position the JACKS DOWN light will go out.
NOTE - If you wish to stop the jacks from retracting, turn the system off and back on again by pushing the on/off pad twice. You can
then re-level the coach by following steps 1-5 again.
3. When the JACKS DOWN light goes out, push the ON/OFF button on the Control Panel to deenergize the system. After a brief visual
inspection around the coach to verify the jacks are fully retracted, you may proceed to travel.
NOTE - When in the MANUAL mode, if the RETRACT button is pushed the jacks will only retract as long as the RETRACT button
is depressed. In AUTOMATIC mode, the RETRACT button need only be pressed once and released for the jacks to fully retract.
OPERATION
SELECTING A SITE
When the coach is parked on an excessive slope the leveling requirements may exceed the jack lift stroke capability. If the coach is
parked on an excessive slope, the coach should be moved to a more level surface before the leveling system is deployed.
AUTOMATIC LEVELING PROCEDURE
NOTE - REFER TO FIG. 4 FOR QUESTIONS REGARDING LOCATION AND FUNCTIONS OF THE LIPPERT COMPONENTS, INC.
ELECTRONIC LEVELING SYSTEM.
NOTE - Coach must be running for LCI Electronic Leveling System to operate.
1. Push ON/OFF button on Control Panel. The system is now operational and the electronic level lights will become active.
2. Check to see that the Control Pad ENGAGE PARK BRAKE light is not flashing.
NOTE - Engage Parking Brake if ENGAGE PARK BRAKE light is flashing.
3. Push the AUTO button to begin the automatic leveling cycle.
WARNING!
After starting the automatic leveling cycle it is very important that you do not move around in the coach until the unit is level
and the green LCI logo light illuminates in the center of the touch pad. Failure to remain still during the leveling cycle could
have an affect on the performance of the leveling system.
4. If further adjustments are necessary, simply push and hold the MAN button for approximately 5 seconds until the light under this
button is illuminated. Push the appropriate leg button to override the system and level the coach to your liking.
WARNING!
NEVER LIFT ALL THE WHEELS OFF THE GROUND TO LEVEL THE COACH!
Lifting all wheels of the ground may resultin serious personal injury or death.
5. Push ON/OFF button to de-energize the system.