Lippert Components Ultra Level - Manual (Page 9)

AUTOMATIC SAFETY SHUTOFF
If the control panel is left on and inactive for four minutes it will shut off automatically. To reset the system the coach ignition must be
turned off, then back on and the ON/OFF button must again be pushed.
DRIVE AWAY PROTECTION SYSTEM
If the ignition is in the “RUN” position, jacks are down, and the operator releases the parking brake, all indicator lights will flash and the
alarm beeper will activate. The system will then automatically retract the jacks until the jacks are fully retracted or the operator resets
the parking brake.
“JACKS DOWN” ALARM
The Lippert Electronic Leveling System is designed to sound an alarm and illuminate the control panel in the event of two (2) possible
scenarios:
1. A “RETRACT” hose leaks.
2. The pressure holding the jacks in the retracted position falls to a approximately 1500 psi to sound the alarm.
If the alarm sounds and the control panel illuminates and flash while driving the vehicle;
3. Immediately find an area to safely pull the vehicle off of the roadway.
4. Set the PARKING BRAKE.
5. Inspect all jacks hoses and check valve for leaks.
6. If no leaks are observed;
a. Turn control panel “ON.”
b. Push “RETRACT ALL JACKS” button.
c. Wait until “JACKS DOWN” light and alarm are off.
d. Inspect jacks. If jacks are retracted and no leaks are observed, vehicle can be driven.
If system is leaking or alarm does not subside after applying the above procedure, disconnect wires from pressure switch and proceed
immediately to a service center. For prolonged travel to the service center, be sure to stop and check the disposition of the leveling
jacks every so often to make sure they are not extending.