Lippert Components Ultra Level - Manual (Page 8)

MANUAL OVERRIDE - POWER SYSTEM
The Lippert Electronic Leveling System can be run with auxiliary power devices like electric drills, ratchet wrenches or cordless
screwdrivers. In the event of electrical or system failure, this manual method of extending and retracting the jacks can be used. A
standard handheld drill is all that is required. See the instructions below.
Fig. 6
1. Remove plastic cap. (See Fig 6).
2. Using a 1/2” socket, insert into auxiliary drive
device, i.e. cordless or power drill 3. Insert 1/2” socket onto coupler found under plastic
cap, Fig. 7.
4. Run drill forward or clockwise to retract jacks.
Fig. 7
MANUAL OVERRIDE - JACKS
In the event that the jacks will not extend or retract, the valves can be manually overridden. By using a 5/32” allen wrench (Pre-2006
model year, see update below) to turn the manual override clockwise on the valve, see Fig. 5a, the leveling jacks can then be extended
or retracted. Remember to turn the manual override completely counterclockwise, see Fig. 5b, until it will no longer turn, to close the
valve after the jacks have been completely extended or retracted.
Fig. 5a
Clockwise for manual override
Fig. 5b
Counter-clockwise for normal operation