Lippert Components Xl Hydraulic Slideout And Hydraulic Landing Gear (hlg) System - Manual (Page 5)

PREVENTATIVE MAINTENANCE PROCEDURES
The Lippert XL Hydraulic Slideout and HLG System has been designed to require
very little maintenance. To ensure the long life of your system, read and follow
these few simple procedures.
1. Change fluid every 36 months (in reservoir ONLY!).
a) Check fluid only when jacks and slideouts are fully retracted.
b) Always fill the reservoir with the jacks and slideouts are in the fully retracted
position. Filling reservoir when jacks and slideouts are extended will cause
reservoir to overflow into its compartment when jacks and slideouts are
retracted.
c) When checking fluid level, fluid should be within 1/2” of fill spout lip.
2. Check the fluid level every month.
3. Inspect and clean all Pump Unit electrical connections every 12 months.
4. Remove dirt and road debris from jacks and slideout arms and cylinders as
needed.
WARNING!
YOUR COACH SHOULD BE SUPPORTED AT BOTH FRONT AND REAR
AXLES WITH JACK STANDS BEFORE WORKING UNDERNEATH.
FAILURE TO DO SO MAY RESULT IN PERSONAL INJURY OR DEATH.
5. If jacks are down and/or slideouts are extended for lengthy periods, it is
recommended to spray exposed jack and cylinder rods with a silicone lubricant
every seven days for protection. If your coach is located in a salty environment, it
is recommended to spray the rods every 2 to 3 days
.
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONSULT YOUR LOCAL
AUTHORIZED DEALER OR CALL LIPPERT AT:
(866) 524-7821.
WARNING!
DO NOT WORK ON YOUR SLIDEOUT SYSTEM UNLESS THE BATTERY IS
DISCONNECTED. FAILURE TO ACT IN ACCORDANCE WITH THE
FOLLOWING MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH.
5