Lippert Components Xl Hydraulic Slideout And Hydraulic Landing Gear (hlg) System - Manual (Page 9)

EXTENDING SLIDEOUT ROOM
1. Level the unit.
2. Verify the battery is fully charged and hooked-up to the electrical system.
3. Remove the transit bars (if so equipped).
4. Press and hold the IN/OUT switch (Fig. 2) in the OUT position until the room
is fully extended and stops moving.
5. Release the switch, which will lock the room into position.
RETRACTING SLIDEOUT ROOM
1. Verify the battery is fully charged and hooked-up to the electrical system.
2. Press and hold the IN/OUT switch (Fig. 1) in the IN position until the room is
fully retracted and stops moving.
3. Release the switch, which will lock the room into position.
4. Install the transit bars (if so equipped).
9